Cisco SCE 8000 Installation And Configuration Manual page 169

Chapter 9 Removal and Replacement Procedures
Carefully slide the module into the slot until the EMI gasket along the top edge of the module makes
Step 8
contact with the module in the slot above it and both ejector levers have closed to approximately 45
degrees in relation to the module faceplate. (See
Figure 9-12
Using the thumb and forefinger of each hand, grasp the two ejector levers and press down to create a
Step 9
small (0.040 inch [1 mm]) gap between the module EMI gasket and the module above it. (See
Figure
Do not press down too forcefully on the ejector levers. They can bend and be damaged.
Caution
Clearing the EMI Gasket
Press down
FA N ST SCE 8000
-SCM -E
AT US
SCM 1
OPT ICAL
BYP ASS
CON SOL
E
POR T 1
10 100 STA TUS
LINK
1000 OPT ICA
ACTI VE
L BYP ASS
SCE 8000
-SCM -E
SCM 2
OPT ICAL
BYP ASS
CON SOL
E
POR T 1
10 100 STA TUS
LINK
1000
ACTI VE OPT ICA
L BYP ASS
SCE 8000
-SIP
SIP 3
SPA- 1X10
GE-L -V2
SPA- 1X10
GE-L -V2
4
SC E8 00 TX
TX
0- FA N
TX
A C
RX TX CTR L
B
RX D
A B
RX
C
RX D
STA TUS
OP TIC AL
BY PA SS OP B-S
1 CE 8K -MM
9-12.)
Figure 9-12.)
Press down
SCE8 000
EXTE NDED
SERV ICE
CONT ROL
MODU LE
MAS TER
SYS TEM
POW ER
SCE8 000
EXTE NDED
SERV ICE
CONT ROL
MODU LE
MAS TER
SYS TEM
POW ER
SPA- 1X10
GE-L -V2
SPA- 1X10
GE-L -V2
1mm Gap between the module
EMI gasket and the
module above it.
Cisco SCE8000 GBE Installation and Configuration Guide
Installing a Module
9-19