Cisco SCE 8000 Installation And Configuration Manual page 204

Informational Messages, Severity Level 6
Error Message %LOCAL7-6-ENABLED_CONF_CHANGED: "Attack-filter configuration was <%s>
for some (or all) attack types."
Explanation
Recommended Action
Error Message %LOCAL7-6-HOST_NAME_CHANGED: "System hostname changed to hostname.
Explanation
configured host name.
In this message, hostname is the new host name.
Recommended Action
Error Message %LOCAL7-6-FLASH_TO_DEFAULT_CALLED: CPU#000 'Reset to Default' called."
Explanation
configurations to factory default configurations.
Recommended Action
Error Message %LOCAL7-6-
Explanation
SCE configurations to factory default configurations.
Recommended Action
Error Message %LOCAL7-6-SOFT_RESET_AND_REFRESH_OK_USER: "Linecard in slot
slot-number was soft-reset and refreshed with all data."
Explanation
refreshed with all the data. (The soft reset refreshes the linecard to the state it was in before the
reset).
Recommended Action
Error Message %LOCAL7-6-REBOOTCC_CALLED:"Rebooting the box per user request."
Explanation
request.
Recommended Action
Cisco SCE8000 GBE Installation and Configuration Guide
C-8
This message is displayed to indicate the status of the attack filter configuration.
None.
This message is displayed to indicate that the system hostname is changed to the
None.
This message is displayed to indicate that the system has started resetting the Cisco SCE
None.
FLASH_TO_DEFAULT_FINISHED: "'Reset to Default' finished."
This message is displayed to indicate that the system has completed resetting the Cisco
None.
This message is displayed to indicate that the linecard in the slot has been soft reset and
None.
This message is displayed while rebooting the Cisco SCE 8000 platform on a user's
None.
Appendix C Cisco Service Control Engine System Log Messages