Cisco SCE 8000 Installation And Configuration Manual page 239

Appendix C Cisco Service Control Engine System Log Messages
Warning Message %LOCAL7-4-DBG_INIT_FAILED_OPEN_FILES: "DBG Init failure
Explanation
Recommended Action
Warning Message %LOCAL7-4-DBG_INIT_FAILED_OPEN_HIST_FILES: "DBG Init failure
Explanation
existing histogram file.
Recommended Action
Warning Message %LOCAL7-4-DBG_INIT_FAILED_LOAD_HIST_FILES: "DBG Init failure:
Failed loading histogram file (bad file or format)."
Explanation
histogram file due to the following reasons:
–
–
–
Recommended Action
Warning Message %LOCAL7-4-DBG_INIT_HEADERS_CORRUPTED1: "DBG Init problem
Explanation
corrupted even if the file is not in the full, empty, or active state.
Recommended Action
Warning Message %LOCAL7-4-DBG_INIT_FAILED_AFTER_HC1: "DBG Init failure
Explanation
debug file, and this operation is attempted when there is an error in the header obtained from the
first debug log file because it is corrupted, that is, the file is not in the full, empty, or active state.
Recommended Action
Warning Message %LOCAL7-4-DBG_INIT_HEADERS_CORRUPTED2: "DBG Init problem
Explanation
corrupted, that is, the file is not in the full, empty, or active state.
Recommended Action
This message is generated while opening new files for logging failure cases.
None.
This message is generated when failure occurs while opening a new histogram file or an
None.
This message is generated when Cisco SCE fails to load the watermarks from the
Failed to read and find the histogram file.
Watermark found, but failed to be removed from the message hash.
Watermark not found in the histogram file.
None.
This message is generated when the header obtained from the first debug log file is
None.
This message is generated when there is an unsuccessful attempt to open or create a new
None.
This message is generated when the header obtained from the second debug log file is
None.
Warning Messages, Severity Level 4
Cisco SCE8000 GBE Installation and Configuration Guide
C-43