Service Control Module (Cisco Sce 8000-Scm-E) - Cisco SCE 8000 Installation And Configuration Manual

Service Control Module (Cisco SCE 8000-SCM-E)

Service Control Module (Cisco SCE 8000-SCM-E)
The Cisco SCE 8000 GBE contains one or two Cisco SCE 8000-SCMs located in slots 1 and 2 (the top
two slots). If only one Cisco SCE 8000-SCM module is installed, it must be installed in slot 1.
The Cisco SCE 8000-SCM in slot 1 performs the following functions:
•
•
•
The Cisco SCE 8000-SCM in slot 2 serves only DPI and traffic processing purposes, doubling the
performance and capacity of the Cisco SCE 8000. Although the two modules are identical (with the same
ports and LEDs), this second SCM module does not run chassis management or control software.
The Service Control module contains ports and LEDs as shown in
and
Figure 2-2
SCE8000-SCM-E
Although the Cisco SCE 8000-SCM module in slot 2 contains all the ports listed in
Note
are not used. All connections should be made to the Cisco SCE 8000-SCM module in slot 1.
Table 2-2
Port
10/100/1000
Console
AUX
Bypass
Cisco SCE8000 GBE Installation and Configuration Guide
2-4
Service engine (Deep Packet Inspection (DPI)) and traffic processing
Management interfaces and functionality
Chassis control and management
Table 2-3.
Cisco SCE 8000-SCM-E
OPTICAL
CONSOLE PORT1
BYPASS1
10/100/ LINK/
1000 ACTIVE
Cisco SCE 8000-SCM-E Ports
Quantity
2 (Port1 and
Port2)
1
1
2
Chapter 2 Introduction to the Cisco SCE 8000 10 GBE Platform
STATUS
OPTICAL BYPASS
OPTICAL
AUX PORT2
BYPASS2
10/100/ LINK/
1000 ACTIVE
Description
10/100/1000 Ethernet RJ-45
ports for management of the
Cisco SCE 8000.
CLI designation: interface
GigabitEthernet 1/1, 1/2
OR
interface MNG 01, 0/2
RS-232 RJ-45 port used by
technicians.
RS-232 RJ-45 port used by
technicians.
RJ-11 port.
Figure 2-2, and described in
SCE8000 EXTENDED SERVICE CONTROL MODULE
MASTER
SYSTEM POWER
Table 2-2, these ports
Connect This Port To...
A LAN using a GBE cable with
an RJ-45 connector.
If both interfaces are used to
provide a redundant
management interface, connect
both ports to the LAN via a
switch.
A local terminal (console) using
an RS-232 cable with an RJ-45
connector, as provided in the
Cisco SCE 8000 kit.
—
The control connector on the
optical bypass module.
Table 2-2