Cisco SCE 8000 Installation And Configuration Manual page 218

Informational Messages, Severity Level 6
Error Message %LOCAL7-6-REPLACE_ENDED: "Application replace ended on slot %ld,
replace finished."
Explanation
Recommended Action
Error Message %LOCAL7-6-TRAVERSING_ALL: "slot number %d analyzing transport layer
information"
Recommended Action
management through the CLI to parse the transport layer instead of performing payload operation
of a packet for analysis. The user can specify whether or not to scan only the payload or the entire
transport layer of the packet for analysis.
Recommended Action
Error Message %LOCAL7-6-TRAVERSING_ONLY_PAYLOAD: "slot number %d analyzing payload
only"
Explanation
number that is allowed to traverse only the payload.
Recommended Action
Error Message %LOCAL7-6-DAEMON_ENABLED: "Telnet daemon was enabled."
Explanation
Recommended Action
Error Message %LOCAL7-6-DAEMON_DISABLED: "Telnet daemon was disabled."
Explanation
Recommended Action
Error Message %LOCAL7-6-DEBUG_TELNET_ACCESS: "<%s> access to debug-telnet (port
2300)"
Explanation
Recommended Action
Error Message %LOCAL7-6-DEBUG_SHELL_ACCESS: "<%s> access to debug-shell (port 2301)"
Explanation
Recommended Action
Cisco SCE8000 GBE Installation and Configuration Guide
C-22
This message is displayed when application replacement is completed.
None.
This message is displayed when a request is made by a user from external
None.
This message defines the details of the traverse layer in a particular slot with the slot
None.
This message is displayed when the telnet process daemon is enabled.
None.
This message is displayed when the telnet process daemon is disabled.
None.
This message is displayed when debug telnet access to port 2300 is enabled.
None.
This message is displayed when debug shell access to port 2301 is enabled.
None.
Appendix C Cisco Service Control Engine System Log Messages