Cisco SCE 8000 Installation And Configuration Manual page 140

Information About Troubleshooting Tools
Following is a sample output from the show telnet command:
show telnet sessions
There is 1 active telnet session:
Index | Source
================
0
show telnet status
Telnet deamon is enabled.
–
Following is a sample output from the show line vty timeout command:
Timeout is 30 minutes
• Troubleshooting the link interface subsystem:
–
Following is a sample output from the show interface command:
Auto negotiation configured: Disabled
Actual status:
Link is: ON
Auto negotiation: Disabled
Bandwidth (L1): 10000000 Kbps, Burst-size: 500000 bytes
Pseudo IP Address: Not Configured
–
Following is a sample output from the show interface counters command:
L2 In total octets: 792000
In good unicast packets: 12000
In good multicast packets: 0
In good broadcast packets: 0
In packets discarded: 0
In packets with CRC/Alignment error: 0
In undersized packets: 0
In oversized packets: 0
Rx pause packets: 0
L2 Out total octets: 0
Out unicast packets: 0
Out good multicast packets: 0
Out good broadcast packets: 0
Out packets discarded: 0
Tx pause packets: 0
Tx regular collision events: 0
L2 Bandwidth Kbps (Rx + Tx): 0
# of packets received of length (in octets):
64: 0, 65-127: 12000, 128-255: 0,
256-511: 0, 512-1023: 0, 1024-1518: 0,
1519+: 0
See Troubleshooting with the User Log, page 8-13
log.
Cisco SCE8000 GBE Installation and Configuration Guide
8-4
| 10.1.1.201
show line vty timeout—Shows the timeout configured for Telnet sessions.
show interface TenGigabitEthernet 3/#/0—Displays information for a specific 10 GBE
Interface.
show interface TenGigabitEthernet 3/#/0 counters—Displays the values of counters of a
GBE interface.
for an explanation of commands related to the user
Chapter 8 Troubleshooting