Attaching The Front-Mount Brackets To The Chassis - Cisco MDS 9396V Installing

Attaching the Front-Mount Brackets to the Chassis

Step 6
Check the two installed bottom support rails to be sure that both rails are level and level with each other. If they are not
level, adjust the higher rail down to the level of the lower rail.
What to do next
You are ready to install two front-mount brackets on the chassis.
Attaching the Front-Mount Brackets to the Chassis
To attach the front mounting brackets to the chassis, perform the following steps:
Before you begin
• You need to attach a right-angled bracket to each side of the chassis. This bracket holds the chassis in
• You must have a Phillips-head torque screwdriver.
Step 1 Align the two holes in one side of one of two front-mount brackets to two holes on the left or right side of the chassis
(see the following figure). Be sure that the other side of the bracket is facing towards the front (port end) of the chassis.
Figure 4: Aligning and Attaching Front-Mount Brackets to the Sides of the Chassis
Installing the Cisco MDS 9396V Switch
12
place on a four-post rack.
Installing the Cisco MDS 9396V Switch