Chapter 5 Connecting The Management Interfaces; Introduction - Cisco SCE 8000 Installation And Configuration Manual

Connecting the Management Interfaces
Revised: August 26, 2014

Introduction

This chapter explains how to connect the Cisco SCE 8000 Service Control Module (Cisco SCE
8000-SCM-E) to a local console and perform the initial system configuration.
Additionally, this chapter contains instructions for cabling the 10/100/1000 Ethernet management
interfaces.
The Console interface (CON) as well as the management interfaces (Port1 and Port2) are located on the
Cisco SCE 8000-SCM-E located in slot 1 of the Cisco SCE 8000 chassis (see the
Module (Cisco SCE 8000-SCM-E)" section on page
This chapter contains the following sections:
•
•
•
How to Set Up the Local Console, page 5-2
Initial Setup Parameters, page 5-3
Connecting the Management Interfaces, page 5-5
C H A P T E R
2-4".
Cisco SCE8000 GBE Installation and Configuration Guide
5
""Service Control
5-1