Alcatel-Lucent 7210 SAS M User Manual page 303

-------------------------------------------------------------------------------
Peer 10.8.100.15
-------------------------------------------------------------------------------
Admin State
Hold Time
Keepalive Timeout
Passive Mode
Active Adjacencies : 1
Tunneling
Lsp Name
Local LSR
BFD Status
===============================================================================
*A:SRU4>config>router>ldp#
peer-parameters
Syntax peer-parameters peer-ip-address
Context show>router>ldp
Description
This command displays LDP peer information.
Parameters
peer-ip-address — Specify the peer IP address.
LDP peer-parameters output — The following table describes LDP peer-parameters output.
Sample Output
7210SAS# show router ldp peer-parameters
===============================================================================
LDP Peers
===============================================================================
-------------------------------------------------------------------------------
Peer : 3.3.3.3
-------------------------------------------------------------------------------
TTL Security
Authentication Key : Disabled
Auth key chain
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide
: Up
: 45
: 40
: Disabled
: Disabled
: None
: None
: Disabled
Label
Peer
TTL security
Min-TTL-Value
Auth
: Disabled
: n/a
Oper State
Hello Factor
Keepalive Factor
Last Modified
Auto Created
The IP address of the peer.
Enabled — LDP peering sessions protected.
Disabled — LDP peering sessions unprotected.
Displays the minimum TTL value for an incoming packet.
Enabled — Authentication using MD5 message based digest proto-
col is enabled.
Disabled — No authentication is used.
Min-TTL
DOD
: Up
: 3
: 4
: 03/03/2010 19:47:34
: No
Description
: n/a
: Enabled
LDP
Page 303