Alcatel-Lucent 7210 SAS M User Manual page 181

LSP Up Time
Transitions
Retry Limit
Signaling
Hop Limit
Fast Reroute/
FastFail Config
ADSPEC
Primary
Secondary
Bandwidth
LSP Up Time
LSP Tunnel ID
To
LSP Down Time
Path Changes
Retry Timer
Resv Style
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide
Label
The length of time the LSP has been operational.
The number of transitions that have occurred for the LSP.
The number of attempts that the software should make to re-establish
the LSP after it has failed.
Specifies the signaling style.
The maximum number of hops that an LSP can traverse, including the
ingress and egress routers.
enabled — Fast reroute is enabled. In the event of a failure, traffic
is immediately rerouted on the pre-computed detour LSP, thus mini-
mizing packet loss.
disabled — There is no detour LSP from each node on the primary
path.
enabled — The LSP will include advertising data (ADSPEC)
objects in RSVP messages.
disabled — The LSP will not include advertising data (ADSPEC)
objects in RSVP messages.
The preferred path for the LSP.
The alternate path that the LSP will use if the primary path is not avail-
able.
The amount of bandwidth in megabits per second (Mbps) reserved for
the LSP path.
The total time in increments that the LSP path has been operational.
The value which identifies the label switched path that is signaled for
this entry.
The IP address of the egress router for the LSP.
The total time in increments that the LSP path has not been opera-
tional.
The number of path changes this LSP has had. For every path change
(path down, path up, path change), a corresponding syslog/trap (if
enabled) is generated.
The time, in seconds, for LSP re-establishment attempts after an LSP
failure.
se — Specifies a shared reservation environment with a limited res-
ervation scope. This reservation style creates a single reservation over
a link that is shared by an explicit list of senders.
Description (Continued)
MPLS and RSVP
Page 181