Alcatel-Lucent 7210 SAS M User Manual page 123

to
Syntax to ip-address
Context config>router>mpls>static-lsp
Description This command specifies the system IP address of the egress router for the static LSP. This command
is required while creating an LSP. For LSPs that are used as transport tunnels for services, the to IP
address must be the system IP address. If the to address does not match the SDP address, the LSP is
not included in the SDP definition.
Parameters
ip-address — The system IP address of the egress router.
Default none
static-lsp-fast-retry
Syntax static-lsp-fast-retry seconds
[no] static-lsp-fast-retry
Context config>router>mpls
Description
This command specifies the value used as the fast retry timer for a static LSP.
When a static LSP is trying to come up, the MPLS request for the ARP entry of the LSP next-hop
may fail when it is made while the next-hop is still down or unavailable. In that case, MPLS starts a
retry timer before making the next request. This enhancement allows the user to configure the retry
timer, so that the LSP comes up as soon as the next-hop is up.
The no form of the command reverts to the default.
Default
no static-fast-retry-timer
Parameters
seconds — Specifies the value, in seconds, used as the fast retry timer for a static LSP.
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide
Values
1-30
MPLS and RSVP
Page 123