Alcatel-Lucent 7210 SAS M User Manual page 297

Output LDP Discovery Output — The following table describes LDP discovery output fields.
interface
Syntax interface [ip-int-name | ip-address] [detail]
Context show>router>ldp
Description
This command displays configuration information about LDP interfaces.
Parameters
ip-int-name — The name of an existing interface. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
ip-address — The IP address of the LDP neighbor.
detail — Displays detailed information.
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide
Label
Interface Name
Local Addr
Peer Addr
Adj Type
State
No. of Hello Adja-
cencies
Up Time
Hold-Time Remain-
ing
Hello Mesg Recv
Hello Mesg Sent
Remote Cfg Seq No
Remote IP Address
Local Cfg Seq No
Local IP Address
The name of the interface.
The IP address of the originating (local) router.
The IP address of the peer.
The adjacency type between the LDP peer and LDP session is targeted.
Established — The adjacency is established.
Trying — The adjacency is not yet established.
The total number of hello adjacencies discovered.
The amount of time the adjacency has been enabled.
The time left before a neighbor is declared to be down.
The number of hello messages received for this adjacency.
The number of hello messages that have been sent for this adjacency.
The configuration sequence number that was in the hello received
when this adjacency started up. This configuration sequence number
changes when there is a change of configuration.
The IP address used on the remote end for the LDP session.
The configuration sequence number that was used in the hello sent
when this adjacency started up. This configuration sequence number
changes when there is a change of configuration.
The IP address used locally for the LDP session.
Description
LDP
Page 297