Alcatel-Lucent 7210 SAS M User Manual page 293

Show LDP Commands
auth-keychain
Syntax auth-keychain [keychain]
Context show>router>ldp
Description
This command displays LDP sessions using a particular authentication key-chain.
Parameters keychain — Specifies an existing keychain name.
Sample Output
*A:ALA-48>config>router>ldp# show router ldp auth-keychain
===============================================================================
LDP Peers
===============================================================================
Peer
-------------------------------------------------------------------------------
10.20.1.3
-------------------------------------------------------------------------------
No. of Peers: 1
===============================================================================
*A:ALA-48>config>router>ldp#
bindings
Syntax bindings [fec-type fec-type [detail]] [session ip-addr[:label-space]]
bindings label-type start-label [end-label]
bindings {prefix ip-prefix/mask [detail]} [session ip-addr[:label-space]]
bindings active [prefix ip-prefix/mask]
bindings service-id service-id [detail]
bindings vc-type vc-type [{vc-id vc-id | agi agi} [session ip-addr[:lab el-space]]
Context show>router>ldp
Description
This command displays the contents of the label information base.
Parameters
detail — Displays detailed information.
label-space — Specifies the label space identifier that the router is advertising on the interface.
start-label — Specifies a label value to begin the display.
end-label — Specifies a label value to end the display.
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide
TTL Security Min-TTL-Value Authentication Auth key chain
Disabled
Values
0 — 65535
Values
16 — 1048575
Values
17 — 1048575
n/a Disabled
LDP
eta_keychain1
Page 293