Alcatel-Lucent 7210 SAS M User Manual page 188

Show Commands
IP Address
Strict/Loose
LSP Name
Binding
Paths
Sample Output
*A:SRU4>config>router>mpls# show router mpls path
===============================================================================
MPLS Path:
===============================================================================
Path Name
-------------------------------------------------------------------------------
to_110_20_1_1
to_110_20_1_2
to_110_20_1_3
to_110_20_1_4
to_110_20_1_5
to_110_20_1_6
to_110_20_1_110
to_10_8_100_15
to_10_20_1_20
to_10_20_1_22
to_10_100_1_1
------------------------------------------------------------------------------
Paths : 11
===============================================================================
*A:SRU4>config>router>mpls#
Page 188
tion Guide
Label
The IP address of the hop that the LSP should traverse on the way to
the egress router.
Strict — The LSP must take a direct path from the previous hop
router to the next router.
Loose — The route taken by the LSP from the previous hop to the
next hop can traverse through other routers.
The name of the LSP used in the path.
Primary — The preferred path for the LSP.
Secondary — The standby path for the LSP.
Total number of paths configured.
Description (Continued)
Adm Hop Index IP Address
Up no hops n/a
Up no hops n/a
Up no hops n/a
Up no hops n/a
Up no hops n/a
Up no hops n/a
Up no hops n/a
Up no hops n/a
Up no hops n/a
Up no hops n/a
Up no hops n/a
7210 SAS M, T, X, R6, Mxp MPLS Configura-
Strict/Loose
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a
n/a