Alcatel-Lucent 7210 SAS M User Manual page 176

Show Commands
bypass-tunnel
Syntax bypass-tunnel [to ip-address] [protected-lsp [lsp-name]] [dynamic | manual] [detail]
Context show>router>mpls
Description If fast reroute is enabled on an LSP and the facility method is selected, instead of creating a separate
LSP for every LSP that is to be backed up, a single LSP is created which serves as a backup for a set
of LSPs. Such an LSP tunnel is called a bypass tunnel.
Parameters
ip-address — Specify the IP address of the egress router.
lsp-name — Specify the name of the LSP protected by the bypass tunnel.
dynamic — Displays dynamically assigned labels for bypass protection.
manual — Displays manually assigned labels for bypass protection.
detail — Displays detailed information.
Output MPLS Bypass Tunnel Output Fields — The following table describes MPLS bypass tunnel out-
put fields.
To
State
Out I/F
Out Label
Reserved BW (Kbps)
Sample Output
*A:Dut-A>show>router>mpls# bypass-tunnel
===============================================================================
MPLS Bypass Tunnels
===============================================================================
Legend :
===============================================================================
To
-------------------------------------------------------------------------------
10.10.36.3
10.10.23.2
10.10.46.4
10.10.36.6
-------------------------------------------------------------------------------
Bypass Tunnels : 4
===============================================================================
*A:Dut-A>show>router>mpls#
Page 176
tion Guide
The system IP address of the egress router.
The LSP's administrative state.
Specifies the name of the network IP interface.
Specifies the incoming MPLS label on which to match.
Specifies the amount of bandwidth in megabits per second (Mbps)
reserved for the LSP.
m - Manual d - Dynamic
State Out I/F
Up lag-1:10
Up lag-1:10
Up lag-2
Up lag-2
Out Label Reserved
BW (Kbps)
131066 0
130454 0
130592 0
130591 0
7210 SAS M, T, X, R6, Mxp MPLS Configura-
Protected Type
LSP Count
2 d
4 d
4 d
2 d