MPLS Commands
slow-psc-timer
Syntax
slow-psc-timer interval
no slow-psc-timer
Context
config>router>mpls>mpls-tp>protection-template
Description
Platforms Supported: 7210 SAS-T network mode and 7210 SAS-R6 devices.
This command configures the slow timer value to be used for protection switching coordination
(PSC) packets for MPLS-TP linear protection (RFC 6378).
Default
no rapid-psc-timer
Parameters
interval — Specifies the slow timer interval.
global-id
Syntax
global-id global-id
no global-id
Context
config>router>mpls>mpls-tp
Description
Platforms Supported: 7210 SAS-T network mode and 7210 SAS-R6 devices.
This command configures the MPLS-TP Global ID for the node. This is used as the 'from' Global ID
used by MPLS-TP LSPs originating at this node. If a value is not entered, the Global ID is taken to be
Zero. This is used if the global-id is not configured. If an operator expects that inter domain LSPs will
be configured, then it is recommended that the global ID should be set to the local ASN of the node,
as configured under config>system. If two-byte ASNs are used, then the most significant two bytes
of the global-id are padded with zeros.
In order to change the value of the global-id, config>router>mpls>mpls-tp must be in the shutdown
state. This will bring down all of the MPLS-TP LSPs on the node. New values a propagated to the
system when a no shutdown is performed.
Default
no global-id
Parameters
global-id — Specifies the global ID for the node.
node-id
Syntax
node-id node-id
no node-id
Context
config>router>mpls>mpls-tp
Description
Platforms Supported: 7210 SAS-T network mode and 7210 SAS-R6 devices.
Page 130
Guide
Values
[10, 100, 1000 ms]
Values
0 — 4294967295
7210 SAS M, T, X, R6, Mxp MPLS Configuration