Alcatel-Lucent 7210 SAS M User Manual page 298

Show Commands
Output LDP Interface Output — The following table describes the LDP interface output fields.
Sample Output
*A:ALU_SIM11>show>router>ldp# interface
===============================================================================
LDP Interfaces
===============================================================================
Interface
-------------------------------------------------------------------------------
a
-------------------------------------------------------------------------------
No. of Interfaces: 1
===============================================================================
Page 298
Guide
Label
Interface
Adm
Opr
Hello Factor
Hold Time
KA Factor
KA Timeout
Auth
No. of Interface
Specifies the interface associated with the LDP instance.
Up — The LDP is administratively enabled.
Down — The LDP is administratively disabled.
Up — The LDP is operationally enabled.
Down — The LDP is operationally disabled.
The value by which the hello timeout should be divided to give the
hello time, for example, the time interval, in seconds, between LDP
hello messages. LDP uses hello messages to discover neighbors and to
detect loss of connectivity with its neighbors.
The hello time, also known as hold time. It is the time interval, in sec-
onds, that LDP waits before declaring a neighbor to be down. Hello
timeout is local to the system and is sent in the hello messages to a
neighbor.
The value by which the keepalive timeout should be divided to give the
keepalive time, for example, the time interval, in seconds,
between LDP keepalive messages. LDP keepalive messages are sent to
keep the LDP session from timing out when no other LDP traffic is
being sent between the neighbors.
The time interval, in seconds, that LDP waits before tearing down a
session. If no LDP messages are exchanged during this time interval,
the LDP session is torn down. Generally the value is configured to be 3
times the keepalive time (the time interval between successive LDP
keepalive messages).
Enabled — Authentication using MD5 message based digest proto-
col is enabled.
Disabled — No authentication is used.
The total number of LDP interfaces.
Adm Opr Hello
Factor Time
Up Up 3
7210 SAS M, T, X, R6, Mxp MPLS Configuration
Description
Hold KA KA
Factor Timeout Address
15 3 30
Transport
System