Alcatel-Lucent 7210 SAS M User Manual page 148

MPLS Commands
must be deleted before the wokring path. Only one protect path can be created for each MPLS-TP
LSP.
The following commands are applicable to the working-tp-path: lsp-num, in-label, out-label, mep,
and shutdown.
lsp-num
Syntax lsp-num lsp-num
no lsp-num
Context config>mpls>lsp>working-tp-path
config>mpls>lsp>protect-tp-path
Description This command configures the MPLS-TP LSP Number for the working TP path or the Protect TP
Path.
Default
no lsp-num
Parameters lsp-num — Specifies the LSP number.
in-label
Syntax in-label in-label
Context config>mpls>lsp>working-tp-path
config>mpls>lsp>protect-tp-path
Description This command configures the incoming label for the reverse path or the working path or the protect
path of an MPLS-TP LSP. MPLS-TP LSPs are bidirectional, and so an incoming label value must be
specified for each path.
Default
no in-label
Parameters in-label — Specifies the in label.
Page 148
Guide
Values
1 — 65535
Default
1 for a working path, 2 for a protect path
Values
32 — 16415
7210 SAS M, T, X, R6, Mxp MPLS Configuration