Alcatel-Lucent 7210 SAS M User Manual page 174

Interface Commands
Message Pacing Commands
msg-pacing
Syntax [no] msg-pacing
Context config>router>rsvp
Description This command enables RSVP message pacing in which the specified number of RSVP messages,
specified in the max-burst command, are sent in a configured interval, specified in the period
command. A count is kept of the messages that were dropped because the output queue for the
interface used for message pacing was full.
Default no msg-pacing
max-burst
Syntax max-burst number
no max-burst
Context config>router>rsvp>msg-pacing
Description
This command specifies the maximum number of RSVP messages that are sent in the specified
period under normal operating conditions.
Default 650
Parameters
number —
period
Syntax period milli-seconds
no period
Context config>router>rsvp>msg-pacing
Description
This command specifies the time interval, in milliseconds, when the router can send the specified
number of RSVP messages which is specified in the max-burst command.
Default
100
Parameters
milli-seconds —
Page 174
Guide
Values 100 — 1000 in increments of 10
Values
100 — 1000 milliseconds in increments of 10 milliseconds
7210 SAS M, T, X, R6, Mxp MPLS Configuration