Alcatel-Lucent 7210 SAS M User Manual page 205

• The specified new-path-name value does not correspond to a previously defined path.
• The specified new-path-name value exists but is being used by any path of the same LSP, includ-
When you execute this command, MPLS performs the following procedures:
• MPLS performs a single MBB attempt to move the LSP path to the new path.
• If the MBB is successful, MPLS updates the new path
• If the MBB is not successful, the path retains it current value.
• The update-path MBB has the same priority as the manual re-signal MBB.
resignal
Syntax resignal {lsp lsp-name path path-name | delay minutes}
Context tools>perform>router>mpls
Description
This command resignal is a specific LSP path. The minutes parameter configures the global timer or
all LSPs for resignal. If only lsp-name and path-name are provided, the LSP will be resignaled imme-
diately.
Parameters
lsp-name — Specifies an existing LSP name to resignal.
path-name — Specifies an existing path name to resignal.
delay minutes — Configures the global timer or all LSPs to resignal.
tp-tunnel
Syntax tp-tunnel
Context tools>perform>router>mpls
Description
Platforms Supported: 7210 SAS-R6
This command enables the context to perform Linear Protection operations on an MPLS-TP LSP.
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide
ing this one.
– MPLS writes the corresponding NHLFE in the data path if this path is the current backup path
for the primary.
– If the current path is the active LSP path, it will update the path, write the new NHLFE in the
data path that will cause traffic to switch to the new path.
MPLS and RSVP
Page 205