Alcatel-Lucent 7210 SAS M User Manual page 294

Show Commands
vc-type — Specifies the VC type to display.
vc-id — Specifies the VC ID to display.
service-id — Specifies the service ID number to display.
Output LDP Bindings Output — The following table describes the LDP bindings fields.
Sample Output
*A:Dut-A# show router ldp bindings
===============================================================================
LDP LSR ID: 10.20.1.1
Page 294
Guide
Values
ethernet , vlan , mirror
Values 1 — 4294967295
Values
1 — 2147483647
Label
U: Label In Use
Legend
N: Label Not In Use
W: Label Withdrawn
S: Status Signaled Up
D: Status Signaled Down
E: Epipe service
V: VPLS service
M: Mirror service
The service type exchanging labels. The possible types displayed are
Type
VPLS, Epipe, Spoke, and Unknown.
The value used by each end of an SDP tunnel to identify the VC.
VCId
The unique service identification number identifying the service in the
SvcID
service domain.
Peer The IP address of the peer.
Displays the LSP Tunnel ID (not the LSP path ID).
EgrIntf/LspId
The ingress LDP label.
IngLbl
U — Label in use.
R — Label released.
The egress LDP label.
EgrLbl
The local MTU value.
LMTU
RMTU The remote MTU value.
The total number of LDP bindings on the router.
No. of Service
Bindings
Description
7210 SAS M, T, X, R6, Mxp MPLS Configuration
A: Apipe service
F: Fpipe service
I: IES service
R: VPRN service
P: Ipipe service
WP: Label Withdraw Pending
C: Cpipe service
TLV: (Type, Length: Value)