Alcatel-Lucent 7210 SAS M User Manual page 187

LSP Number
Forward Path configuration
In Label
Out Interface : CtoB_1
Reverse Path configuration
In Label
Out Interface : CtoA_1
===============================================================================
A:mplstp-dutC#
srlg-database
Syntax srlg-database [router-id ip-address] [interface ip-address]
Context show>router>mpls
Description
This command displays MPLS SRLG database information.
Parameters router-id ip-address — Specifies a 32-bit integer uniquely identifying the router in the Autonomous
interface ip-address — Specifies the IP address of the interface.
path
Syntax path [path-name] [lsp-binding]
Context show>router>mpls
Description This command displays MPLS paths.
Parameters
path-name — The unique name label for the LSP path.
lsp-binding — Keyword to display binding information.
Output MPLS Path Output — The following table describes MPLS Path output fields.
Path Name
Adm
Hop Index
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide
: 2
: 2080
: 2081
System. By convention to ensure uniqueness, this may default to the value of one of the router's
IPv4 host addresses, represented as a 32-bit unsigned integer, if IPv4 is configured on the router.
The router-id can be either the local one or some remote router.
Label
The unique name label for the LSP path.
Down — The path is administratively disabled.
Up — The path is administratively enabled.
The value used to order the hops in a path.
MPLS and RSVP
Dst Tunnel Num: 32
Out Label : 2081
Next Hop Addr : n/a
Out Label : 2080
Next Hop Addr : n/a
Description
Page 187