Alcatel-Lucent 7210 SAS M User Manual page 300

Show Commands
*A:SRU4>config>router>ldp# show router ldp parameters
===============================================================================
LDP Parameters (LSR ID 110.20.1.4)
===============================================================================
-------------------------------------------------------------------------------
Graceful Restart Parameters
-------------------------------------------------------------------------------
Nbor Liveness Time : 5 sec
-------------------------------------------------------------------------------
Interface Parameters
-------------------------------------------------------------------------------
Keepalive Timeout
Hold Time
Propagate Policy
Deaggregate FECs
Label Distribution : downstreamUnsolicited Label Retention
Control Mode
-------------------------------------------------------------------------------
Targeted Session Parameters
-------------------------------------------------------------------------------
Keepalive Timeout
Hold Time
Passive Mode
===============================================================================
*A:SRU4>config>router>ldp#
peer
Syntax peer [ip-address] [detail]
Context show>router>ldp
Description
This command displays configuration information about LDP peers.
Parameters
ip-address — The IP address of the LDP peer.
detail — Displays detailed information.
Output LDP Peer Output — The following table describes LDP peer output.
Page 300
Guide
: 30 sec
: 15 sec
: system
: False
: ordered
: 40 sec
: 45 sec
: False
Label
Peer
Adm
Opr
Hello Factor
Max Recovery Time : 30
Keepalive Factor
Hello Factor
Transport Address : system
Route Preference
Loop Detection
Keepalive Factor
Hello Factor
Targeted Sessions : Enabled
The IP address of the peer.
Up — The LDP is administratively enabled.
Down — The LDP is administratively disabled.
Up — The LDP is operationally enabled.
Down — The LDP is operationally disabled.
The value by which the hello timeout should be divided to give the
hello time, for example, the time interval, in seconds, between LDP
hello messages. LDP uses hello messages to discover neighbors and to
detect loss of connectivity with its neighbors.
7210 SAS M, T, X, R6, Mxp MPLS Configuration
: 3
: 3
: 9
: liberal
: none
: 4
: 3
Description