Alcatel-Lucent 7210 SAS M User Manual page 132

MPLS Commands
The no form of the command removes the path ID from the configuration.
Default no path-id
Parameters
lsp-num — Specifues the LSP number.
src-global-id — Specifies the source global ID.
src-node-id — Specifies the source node ID.
src-tunnel-num — Specifies the source tunnel number.
dest-global-id — Specifies the destination global ID. If the destination global ID is not entered, then
dest-node-id — Specifies the destination node ID.
dest-tunnel-num — Specifies the destination tunnel number. If the destination tunnel number is not
forward-path
Syntax [no] forward-path
Context config>router>mpls>mpls-tp>transit-path
Description
Platforms Supported: 7210 SAS-T network mode and 7210 SAS-R6 devices.
This command enables the forward path of an MPLS-TP transit path to be created or edited.
The forward path must be created before the reverse path.
The no form of this command removes the forward path. The forward path cannot be removed if a
reverse exists.
Default
no forward-path
Page 132
Guide
Values
1 — 65535, or working path, or protect-path. A working-path is equivalent to a
lsp-num of 1, and a protect-path is an lsp-num of 2.
Values 0 — 4294967295
Values
a.b.c.d or 1 — 4294967295
Values 1 — 61440
it is set to the same value as the source global ID.
Values
0 — 4294967295
Values a.b.c.d or 1 — 4294967295
entered, then it is set to the same value as the source tunnel number.
Values
1 — 61440
7210 SAS M, T, X, R6, Mxp MPLS Configuration