Alcatel-Lucent 7210 SAS M User Manual page 115

dynamic-bypass
Syntax dynamic-bypass [enable | disable]
no dynamic-bypass
Context config>router>mpls
Description This command disables the creation of dynamic bypass LSPs in FRR. One or more manual bypass
LSPs must be configured to protect the primary LSP path at the PLR nodes.
Note :Implict NULL must be enabled for use of Manual Bypass or Dynamic Bypass (FRR facility) if
the 7210 is used as a egress LER and/or is a Merge Point.
Default enable
Note :Implict NULL must be enabled for use of Manual Bypass or Dynamic Bypass (FRR facility) if
the 7210 is used as a egress LER and/or is a Merge Point.
frr-object
Syntax [no] frr-object
Context config>router>mpls
Description
This command specifies whether fast reroute for LSPs using the facility bypass method is signalled
with or without the fast reroute object using the one-to-one keyword. The value is ignored if fast
reroute is disabled for the LSP or if the LSP is using one-to-one Backup.
Default frr-object — The value is by default inherited by all LSPs.
hold-timer
Syntax hold-timer seconds
no hold-timer
Context config>router>mpls
Description
This command specifies the amount of time that the ingress node holds before programming its data
plane and declaring the LSP up to the service module.
The no form of the command disables the hold-timer.
Default 1 second
Parameters
seconds — Specifies the time, in seconds, for which the ingress node holds before programming its
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide
data plane and declaring the LSP up to the service module.
Values
0 — 10
MPLS and RSVP
Page 115