Alcatel-Lucent 7210 SAS M User Manual page 140

MPLS Commands
The no form of this command returns the parameter to the default value.
Default
255
Parameters
number — The number of hops the LSP can traverse, expressed as an integer.
include
Syntax [no] include group-name [group-name...(up to 5max)]
Context config>router>mpls>lsp
config>router>mpls>lsp>primary
config>router>mpls>lsp>secondary
Description
This command specifies the admin groups to be included when an LSP is set up. Up to 5 groups per
operation can be specified, up to 32 maximum.
The no form of the command deletes the specified groups in the specified context.
Default
no include
Parameters group-name — Specifies admin groups to be included when an LSP is set up.
ldp-over-rsvp
Syntax [no] ldp-over-rsvp [include | exclude]
Context config>router>mpls>lsp
Description
This command specifies if this LSP will be included in LDP over RSVP.The no form of the command
reverts to default operation.
Default no ldp-over-rsvp
Parameters
include — Specifies that this LSP will be included in LDP over RSVP.
exclude — Specifies that this LSP will be excluded from LDP over RSVP.
metric
Syntax metric metric
Context config>router>mpls>lsp
Description
This command specifies the metric for this LSP which is used to select an LSP among a set of LSPs
which are destined to the same egress router. The LSP with the lowest metric will be selected.
Page 140
Guide
the new value is equal to or greater than the current number hops of the established LSP, then the
LSP is not affected.
Values
2 — 255
7210 SAS M, T, X, R6, Mxp MPLS Configuration