Alcatel-Lucent 7210 SAS M User Manual page 147

order to delete it. The no secondary path-name command will not result in any action except a
warning message on the console indicating that the secondary path is administratively up.
Default
none
Parameters
path-name — The case-sensitive alphanumeric name label for the LSP path up to 32 characters in
adaptive
Syntax [no] adaptive
Context config>router>mpls>lsp>primary
config>router>mpls>lsp>secondary
Description
This command enables the make-before-break functionality for an LSP or a primary or secondary
LSP path. When enabled for the LSP, make-before-break will be performed for primary path and all
the secondary paths of the LSP.
Default
adaptive
working-tp-path
Syntax [no] working-tp-path
Context config>router>mpls>lsp
Description
This command creates or edits the working path for an MPLS-TP LSP. At least one working path (but
not more than one working path) must be created for an MPLS-TP LSP. If MPLS-TP linear protection
is also configured, then this is the path that is used as the default working path for the LSP, and it must
be created prior to the protect path. The working-tp-path can only be deleted if no protect-tp-path
exists for the LSP.
The following commands are applicable to the working-tp-path: lsp-num, in-label, out-label, mep,
shutdown.
Default
no working-tp-path
protect-tp-path
Syntax [no] protect-tp-path
Context config>router>mpls>lsp
Description This command creates or edits the protect path for an MPLS-TP LSP. At least one working path must
exist before a protect path can be created for an MPLS-TP LSP. If MPLS-TP linear protection is also
configured, then this is the path that is used as the default protect path for the LSP. The protect path
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide
length.
MPLS and RSVP
Page 147