Alcatel-Lucent 7210 SAS M User Manual page 203

Tools Commands
cspf
Syntax cspf to ip-addr [from ip-addr] [bandwidth bandwidth] [include-bitmap bitmap] [exclude-
bitmap bitmap] [hop-limit limit] [exclude-address excl-addr [excl-addr...(up to 8 max)]]
[use-te-metric] [strict-srlg] [srlggroup grp-id...(up to 8 max)] [skip-interface interface-
name]
Context tools>perform>router>mpls
Description
This command computes a CSPF path with specified user constraints.
Default
none
Parameters
to ip-addr — Specify the destination IP address.
from ip-addr — Specify the originating IP address.
bandwidth bandwidth — Specifies the amount of bandwidth in mega-bits per second (Mbps) to be
include-bitmap bitmap — Specifies to include a bit-map that specifies a list of admin groups that
exclude-bitmap bitmap — Specifies to exclude a bit-map that specifies a list of admin groups that
hop-limit limit — Specifies the total number of hops a detour LSP can take before merging back onto
exclude-address ip-addr — Specifies IP addresses, up to 8, that should be included during setup.
use-te-metric — Specifies the use of the traffic engineering metric used on the interface.
strict-srlg — Specifies whether to associate the LSP with a bypass or signal a detour if a bypass or
srlg-group grp-id — Specifies up to 8 Shared Risk Link Groups (SRLGs). An SRLG group
skip-interface interface-name — Specifies an interface name that should be skipped during setup.
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide
reserved.
should be included during setup.
should be included during setup.
the main LSP path.
detour satisfies all other constraints except the SRLG constraints.
represents a set of interfaces which could be subject to the same failures or defects and therefore,
share the same risk of failing.
Values
0 — 4294967295
MPLS and RSVP
Page 203