Alcatel-Lucent 7210 SAS M User Manual page 299

*A:ALU_SIM11>show>router>ldp# interface detail
*A:ALU_SIM11>show>router>ldp#
===============================================================================
LDP Interfaces (Detail)
===============================================================================
Interface "a"
-------------------------------------------------------------------------------
Admin State
Hold Time
Keepalive Timeout
Transport Addr
Active Adjacencies : 1
Tunneling
Lsp Name
===============================================================================
*A:ALU_SIM11>show>router>ldp#
parameters
Syntax parameters
Context show>router>ldp
Description
This command displays configuration information about LDP parameters.
Output LDP Parameters Output — The following table describes the LDP parameters output fields.
Sample Output
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide
: Up
: 15
: 30
: System
: Disabled
: None
Label
Keepalive Timeout
Keepalive Factor
Hold-Time
Hello Factor
Auth
Passive-Mode
Targeted-Sessions
Oper State
Hello Factor
Keepalive Factor : 3
Last Modified
The factor used to derive the Keepalive interval.
The time interval, in seconds, that LDP waits before tearing down the
session.
The time left before a neighbor is declared to be down.
The value by which the hello timeout should be divided to give the
hello time, for example, the time interval, in seconds, between LDP
hello messages. LDP uses hello messages to discover neighbors and to
detect loss of connectivity with its neighbors.
Enabled — Authentication using MD5 message based digest proto-
col is enabled.
Disabled — No authentication is used.
true — LDP responds only when it gets a connect request from a
peer and will not attempt to actively connect to its neighbors.
false — LDP actively tries to connect to its peers.
true — Targeted sessions are enabled.
false — Targeted sessions are disabled.
: Up
: 3
: 07/06/2010 10:36:59
Description
LDP
Page 299