D9824 Receiver Rear Connector Panel - Cisco D9824 Installation And Configuration Manual

D9824 Receiver Rear Connector Panel

The following diagram shows the rear connector panel of the D9824 receiver:
The following table describes the function and type of the various connectors.
Connector
RF Inputs
ASI Input
ASI Output
Management
TS Outputs (2)
Cue Tone/Cue Trigger
Relay Outputs
Composite Video
Outputs
Component Video
Outputs
Balanced Audio Outputs
78-4039426-01 Rev D
Description
Each input accepts an LNB signal input.
RF1 provides LNB power for use when no
external LNB power source is available. RF2
to RF4 require an external LNB power
source.
Asynchronous Serial Interface Input.
One Asynchronous Serial Interface Output.
For code downloading/application
upgrading for the D9824 receiver.
These are for the MPEGoIP and MPE
outputs. The MPEGoIP output of the
transport stream is encapsulated in the IP
packets to a groomer for distribution. The
MPE output receives IP packets from the
transport stream.
Program relay provides programmed
responses for alarms.
CVBS 1 and CVBS 2 provide two identical
SD composite video outputs for monitoring
applications.
SD to HD upconverted component video
output for HD monitoring applications.
Audio 1 and Audio 2 provide two stereo
pairs or four mono channels.

D9824 Receiver Rear Connector Panel

Type
F
BNC
BNC
RJ-45
RJ-45
15-pin sub-D female
BNC
BNC
Terminal Blocks
19