Cue Tone/Cue Trigger Interface - Cisco D9824 Installation And Configuration Manual

Chapter 3 Installation

Cue Tone/Cue Trigger Interface

The D9824 receiver is equipped with a connector labeled Cue Tone/Relay for alarm
relay outputs for remote alarm signaling. This connector provides Cue Tone, Cue
Trigger and Alarm relay functionality. These outputs are user-configurable via the
Setup Menu on the front panel.
The connector is a 15-pin sub-D female connector. The following diagram shows the
connector and the pin allocation table for Cue Tone, Cue Trigger and Alarm relay
connections.
Connector
Connecting the Cue Tone Interface
Connect the Cue Tone pins, 13 and 14 to a device to facilitate ad-insertion using
DTMF Analog Cue Tones.
Connecting the Cue Trigger Interface
Connect the Cue Trigger pins (1 to 8) to up to 8 serial control devices or a device to
control ad-insertion. These outputs are user-configurable on the front panel menu.
24
Pin Pin allocation
1 Cue Trig 1
2 Cue Trig 2
3 Cue Trig 3
4 Cue Trig 4
5 Cue Trig 5
6 Cue Trig 6
7 Cue Trig 7
8 Cue Trig 8
9 Not connected
10 Alarm - Ground
11 Alarm - Normally open
12 Chassis ground
13 Cue Tone -
14 Cue Tone +
15 Alarm - Normally closed
78-4039426-01 Rev D