Table of Contents
Advertisement
Chapter 4 Front Panel Operation
Menu Item
InputIQ
NetID
LNB Power
22kHz
Tune Mode
Custom
This menu is where you set up your custom properties. Select the channel to set up
and then edit it.
62
Description
Select the Input signal spectrum inversion
setting, which allows the operator to track and
select inverted and non-inverted digital
signals. This is normally used to automatically
reject or filter out unwanted signals.
Select the Network ID of the uplink signal the
receiver is to receive. The receiver's Network
ID must match the Network ID associated with
the transmitted signal.
Set the power output of RF1 to the external
LNB.
For dual band applications, select whether to
transmit the 22 kHz tone Local Oscillator
control signal of RF1.
Parameters
Auto, Normal, or
Opposite.
Auto - The signal is
tracked and inverted for
correct selection, as
required.
Opposite - The signal is
always inverted.
Normal - The signal is not
inverted.
1 to 65535. The default
value is 1.
Off, 13V, 18V, V-NIT, or
H-NIT.
V-NIT and H-NIT will use
vertical and horizontal
polarity until it is
automatically read from
the NIT.
Note: Power will not be
applied to the LNB when
set to Off.
On, Off, or Auto.
Auto uses the crossover
frequency to determine if
the tone is transmitted.
78-4039426-01 Rev D
- Quick Links:
- Logging on to the Web Interface
Hide quick links:
Advertisement
Table of Contents
