Cisco D9824 Installation And Configuration Manual page 70

Chapter 4 Front Panel Operation
Menu Item
NetID
TxID
LNB Stat
Polar
LO Select
Program PIDs
Menu Item
PE
Stream
Type
Detail
48
Description
Indicates the Network ID of the uplink
signal the receiver is to receive when
using the selected preset. The receiver's
Network ID must match the Network
ID associated with the transmitted
signal that identifies the NIT to be used.
Note: Each network must be assigned a
unique ID (number).
Indicates the Transport ID.
Indicates the current Low Noise Block
(LNB) connection status.
Indicates the polarity of the LNB Power
supply.
Indicates whether a 22 kHz tone is
available on input port RF1. This is
applicable for dual-band applications.
Description
Select the Program Entry to view.
Indicates the name assigned to the
Program Entry.
Indicates the type of program
associated with the incoming PID.
Indicates any detail associated with
the program PID (e.g., MPG2 PID).
Parameters
1 to 65535
1 to 65535
No Load, Over Loaded, Over
Temperature, Short Circuit,
Disabled, Normal or N/A
Off, 13V, or 18V
On or Off
Parameters
PE1 to PE32
Up to 4 alphanumeric
characters
PMT, PCR, VID, AUD, SUBT,
CDT, ECM, EMM, DATA, MPE,
VBI or DPI
MPG1 VID, MPG2 VID, 422
VID, H264 VID, HD VID, MPG4
VID, MPG AUD, MPG2 AUD,
DVB AC3, DVB DDP, AAC
AUD, HEAAC, AUD, MPG4
AUD, DBE AUD, DTS AUD,
DVB TXT, DVB VBI, DVB
SUBT, DVB ASYN, DVB SYNS,
DVB SYND, DVB MPE, DVB
DCAR, DVB OCAR, SA VBI,
ATSC AC3, ATSC DDP, SA
UTLD, SCTE DPI, SA HSD, SA
CDDL, SA WBD, SA SUBT,
ECM, EMM, PCR, or
UNKNOWN
78-4039426-01 Rev D