Cisco D9824 Installation And Configuration Manual page 197

Output Mode
No Output
Passthrough
Service Channels
Only
MAP Passthrough
MAP Service
Channels Only
Full DPM Control
5 In Descrambled drop-down, select whether the receiver should scramble the
output even if it is authorized to receive the channel. The default is Descrambled.
Descramble Mode
Scrambled
Descrambled
6 Select Yes to insert null packets in the output stream under Null Packet
Insertion. Otherwise, select No. Null packets are always inserted if the Rate
Control is set to User.
7 Select the transport Protocol to be used for the output stream (RTP or UDP).
8 Enter the unicast (valid host IP only) or multicast Destination IP Address
(224.0.0.0 to 239.255.255.255).
9 Select the Destination Port number (1 to 65535).
Note: If you selected RTP as the Protocol, you must select an even destination
port number.
78-4039426-01 Rev D
Description
No MPEGoIP output will be generated.
The output will be identical to the input. The output channel will
not be modified.
PE/PID remapping options, PSI regeneration and User Rate are
not supported in this mode.
Only service channels will be output.
The output will be identical to the input, except that it will be
generated using the DPM and PID mapping settings. If the input
is tuned to a valid channel, the PEs are automatically set to Map.
Otherwise, the PEs are automatically set to Drop.
Note: If the PE is mapped, it uses the last valid input. The output
map (for example, output channel PMT) does not change
automatically if the input or channel number is changed.
Only service channels will be output according to the DPM and
PID mapping settings. If the input is tuned to a valid channel, the
PEs are automatically set to Map. Otherwise, the PEs are
automatically set to Drop.
Note: If the PE is mapped, it uses the last valid input. The output
map (for example, output channel PMT) does not change
automatically if the input or channel number is changed.
The output will be generated according to the DPM settings on the
Digital Program Mapping (MPEG over IP) page. This is a manual
control setting.
Description
Scrambles the output channel even if the PE is authorized and can
descramble the channel.
Descrambles the output channel, and passes in-the-clear channels.
Configuring Transport Stream Information
175