D9824 Receiver Rear Connector Panel - Cisco D9824 Installation And Configuration Manual

D9824 Receiver Rear Connector Panel

The following diagram shows the rear connector panel of the D9824 receiver:
The following table describes the function and type of the various connectors.
Connector
RF Inputs
ASI Input
ASI Output
Management
TS Inputs/Outputs (2)
Cue Tone/Cue Trigger
Relay Outputs
Description
Each input accepts an LNB signal input.
RF1 provides LNB power for use when no
external LNB power source is available. RF2
to RF4 require an external LNB power
source.
Asynchronous Serial Interface Input.
One Asynchronous Serial Interface Output.
Supports the following network protocols:
Telnet, SSHv2, HTTP, HTTPS, SNMPv2,
Syslog/DTX, SNTP, FTP (client side), and
TFTP.
These are for the MPEGoIP Inputs, and
MPEGoIP and MPE outputs.
The MPEGoIP output transmits the
decrypted transport stream encapsulated in
IP packets to a groomer for distribution.
The MPE output receives and outputs the IP
data packets from the incoming transport
stream.
The MPEGoIP input allows the decoder to
receive its streams from the terrestrial IP
network.
Program relay provides programmed
responses for alarms.

D9824 Receiver Rear Connector Panel

Type
F
BNC
BNC
RJ-45
RJ-45
15-pin sub-D female
23