Cisco D9824 Installation And Configuration Manual page 120

Chapter 4 Front Panel Operation
Menu Item
PSI Options
PSI Rate
Service ID
PAT, CAT, PMT,
TSDT, NIT, NITO,
SDT, SDTO, BAT,
EIT, TDT, RST,
TOT, DIT, SIT, ECM,
EMM, DRT, CDT
98
Description
Select the action to perform on
the PSI tables for the output
stream.
Note: The table menus (PAT,
CAT, PMT, TSDT, NIT, NITO,
SDT, SDTO, BAT, EIT, TDT,
RST, TOT, DIT, SIT, ECM,
EMM, DRT, CDT) will only
appear if you select Ctl by
Table.
If the PSI Options was set to
Ctrl by Table, select the
regeneration rate for those PSI
tables being regenerated.
Select whether the receiver
should always generate PSI
tables for the Mapped PE even
if the selected input channel is
not available, or for only valid
service channels/IDs.
Selects the tables which will be
passed, dropped, regenerated,
or passed with rate control
(PwRC) from the output. For
more information, see PSI
Table Settings (on page 100).
Note: The table settings are
only available if you selected
Ctl by Table in the PSI Options
menu.
Parameters
Pass All - Transmits the incoming PSI
Tables as is; does not modify the
content and rate. The PSI Rate and
table settings are ignored.
Drop All - Does not transmit any PSI
Tables. The PSI Rate and table
settings are ignored.
Ctl by Table - Configure the table
specific output mode for each table.
Auto - Matches the generated PSI
tables' output rate to the incoming
rate.
MPEG Min - Transmits the generated
PSI tables on the longest intervals that
are allowed by MPEG standard.
SA Std - Transmits the generated PSI
tables based on PowerVu standard
intervals.
Valid Ch - Only transmits the PSI
tables for the mapped program if the
program exists on the input stream.
All Ch - Transmits the PSI tables for
the mapped program even if the
program does not exist in the input
stream.
All Ch is only valid if the PAT, NIT,
SDT and PMT are set to Regenerate.
78-4039426-01 Rev D