Cisco D9824 Installation And Configuration Manual page 201

Action
Map
11 Enter a Stream Type to map within a PE to a specified PID (0 to 255).
12 Select the output program stream Category or service type. This value is only
used if the Action is set to Map. The categories are: UNKN, CDT, LSDT, DATA,
TTX, MPE, DPI, VBI, SUBT, AUD, VID, PCR or INVL.
13 Enter the Output Stream Instance (1 to 64) and the Output program PID (0 to
8192).
14 To remove a PID mapping, select the entry you want to remove and click Delete.
15 Click OK.
16 In the DPM Program Entry Setup section, each PE output can be synchronized
to its input according to one of the four output modes. Select the program entry
you want to synchronize and then click Resynchronize or click Resynchronize
All to synchronize all the listed PE outputs to its inputs.
Note: The resynchronization will not synchronize the inputs if there is no valid
input on the PE or if the PE is set to channel 0.
The Confirm Resynchronization window is displayed.
17 Select whether you want to synchronize services and PIDs, services only, PIDs
only, or to synchronize using a template.
18 Click Yes.
19 In the DPM General Settings section, you can configure MPEGoIP DPM
transport stream settings.
20 In the Remapping Mode drop-down, select the DPM map mode. The following
table describes each mode:
Map Mode
Svc ID
78-4039426-01 Rev D
Description
Provides the flexibility to define all the outgoing PID numbers for
a PE, including those not currently on transmission.
Description
The elementary PIDs are not changed. Channels are remapped by
changing their PSI references. When this mode is selected, PE
detailed PID mapping cannot be edited.
Configuring Transport Stream Information
179