Setting Up Si Receive Parameters - Cisco D9824 Installation And Configuration Manual

Chapter 5 Web GUI Setup and Monitoring

Setting up SI Receive Parameters

1 From the user interface of the D9824, click Input > Input Setup, expand Input
Setup and then click SI Receive Setup. The SI Receive Setup page is displayed.
2 In the Custom Tuning Mode section, Acquisition Mode drop-down menu,
select the tables required for the service list creation and signal acquisition. The
selections are Auto, Basic, or Custom. The default is Basic. If you select Basic, it
requires NIT to be present. If you select Auto, it uses all the available service list
tables and it will acquire if any table is present.
If you select Custom, click Configure Custom SI Recv and the Configure
Custom SI Recv window opens:
134 78-4039426-01 Rev D