Fcc Notices; Industry Canada Notice; Unauthorized Modifications - Cisco D9824 Installation And Configuration Manual

FCC Notices

This equipment has been tested and found to comply with the limits for a Class B
digital device pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference when operated in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions
supplied in this manual may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception (which can be determined by turning the equipment off and on), the user
is encouraged to try to correct the interference by one or more of the following
measures:
1 Reorient or relocate the television receiving antenna.
2 Increase the separation between the equipment and the receiver.
3 Connect the equipment to an AC outlet on a circuit different from that to which
the receiver is connected.
4 Contact your dealer/ reseller or an experienced radio/ TV technician for help.
The user may find the booklet "Interference handbook" prepared by the Federal
Communications Commission helpful. This booklet is available from the U.S.
Government Printing Office, Washington, DC 20402, stock no. 004-000-00450-7.
Shielded cables should be used to interconnect this device with any other/peripheral
equipment (i.e., data sources, terminals, monitors, etc.) to ensure compliance with
Class B limits. Failure to do so may result in radio or TV interference. Cables should
be of braided shield construction with metal end shells.

Industry Canada Notice

This digital apparatus does not exceed the limits for Class B radio noise emissions
from digital apparatus as set out in the radio interference regulations of the Industry
Canada.
Le present appareil numerique n'emet pas de bruites radioelectriques qui dépassant
les limites applicables aux appareils numeriques de Class B prescrites dans le
reglement sur le brouillage radioelectrique edicte par Industrie Canada.

Unauthorized Modifications

The manufacturer is not responsible for any radio or TV interference resulting from
unauthorized modifications made to this equipment. It is the responsibility of the
user to correct such interference at his own expense.
78-4039426-01 Rev D
Applicable Standards and Notices
309