Front Panel Leds - Cisco D9824 Installation And Configuration Manual

Chapter 6 Service and Maintenance

Front Panel LEDs

To help signal the status of operation or the presence of an alarm, the D9824 receiver
makes use of front panel LEDs. The photograph below shows the location of the
LEDs on the front panel of the D9824 receive.
The functions of the LEDs are described in the table below.
LED
ALARM
SIGNAL
220
Signal State/Color Explanation
Red Solid for five seconds indicates a Warning.
Red Flashing indicates an Alarm.
Green Solid indicates all of the following conditions:


Green Flashing indicates one of the following conditions:





all RF inputs are enabled, all inputs are locked to
a signal, and are not muted.
all routed ASI outputs are operating without an
error.
difficulty with an input, route or output.
one or more RF inputs, or the ASI input are not
synchronized.
one or more ASI outputs are routed, but muted
by a fault condition.
no RF signal is present or detected, or it is muted.
receiver is not authorized to receive the program.
78-4039426-01 Rev D