Cisco D9824 Installation And Configuration Manual page 115

Menu Item
Descramble Mode This parameter selects
Insert Null Packet This parameter selects
DATA1/DATA2
Port Mode
PCR@IP Start
PCR Addition
MOIP
TS/IP
Min IP/s
DestAddr
78-4039426-01 Rev D
Description
whether the receiver should
scramble the output even if
it is authorized to receive
the channel.
whether to insert null
packets in the output
stream.
Null packets are always
inserted if the Rate Control
is set to User.
This selects the Data
MPEGoIP modes.
Note: If No Output was
selected for MOIP1 Output
Mode, updates to the port
modes will have no affect.
This selects whether to
always transmit a new IP
packet when a new
Program Clock Reference
(PCR) arrives.
Note: This is not supported.
This selects whether to add
a PCR to the output stream.
Selects the transport
protocol to be used for the
output stream.
This selects the maximum
number of transport
packets per IP packet.
This selects the minimum
number of IP packets per
second.
Enter the unicast (valid host
IP only) or multicast
destination IP address.
Parameters
The default mode is Descrambled.
Scrambled - Scrambles the output channel
even if the PE is authorized and can
descramble the channel.
Descrambled - Descrambles the output
channel, and passes in-the-clear channels.
Yes or No
No Output - Disables the MPEGoIP
interface.
Always Output - Always outputs data on
the port.
Yes or No
Yes or No
RTP or UDP
1 to 7
3 to 9999
224.0.0.0 to 239.255.255.255
Setup Menu
93