Viewing Psi Frequency Information - Cisco D9824 Installation And Configuration Manual

Viewing PSI Frequency Information

From the user interface of the D9824, click Input > Stream Details > PSI Frequency.
The PSI Frequency page is displayed.
You cannot make any changes in the PSI Frequency table and can only view the
available frequency plans stored in the receiver. The following is a list of the various
columns:
Abbreviation
Transport Stream ID
Frequency (GHz)
Symbol Rate (MSym)
Orbital Position
Polarization
Flag
FEC
RF Modulation
Network ID
78-4039426-01 Rev D
Description
Displays the transport ID.
Displays the downlink frequency, in GHz (0.0 to 15.0 GHz).
Displays the symbol rate, in Mbps.
Displays the orbital position of the satellite, in degrees
(East of West).
Displays the polarity of the received signal (H,V, or Off).
Displays the satellite position (in degrees), in combination
with the direction (East or West).
Indicates the Forward Error Correction inner code rate
(1/2, 3/5, 2/3, 3/4, 4/5, 5/6, 7/8, 8/9, or 9/10).
Indicates the modulation of the signal (QPSK DVB-S, QPSK
DVB-S2, 8PSK DVB-S2 or 16QAM DVB-S2).
Displays the original network ID.
Setting up Input Information
149