Cisco D9824 Installation And Configuration Manual page 196

Chapter 5 Web GUI Setup and Monitoring
Note: After you make any changes, a successfully updated (session open)
message appears. The changes are displayed, but not saved. You must click
Apply to save and apply the changes.
Note: Any changes made to the MOIP DPM values will automatically change the
Output Mode to Full DPM Control, unless the output mode is set to No Output.
2 Select the DPM output Rate Control. The following table describes the affect
each of the settings has on the output bit rate:
Rate Control
Auto
User
3 Enter the output User Rate, which is only used if Rate Control is set to User. If
the output bit rate is less than the input, the output data will be partially or
completely lost.
Note: Output data will be partially lost if the user-selected bit rate is set to a
value that is less than the actual signal bit rate. This allows you to set the output
bit rate to a value expected by equipment connected to the MPEGoIP output.
You can enter a range from 0 to 206 Mbps.
4 Select the DPM Output Mode. The following table describes each mode:
174
Description
The output rate follows that set by the uplink. The output rate will
be the same as the input rate (including all null packets). This
means the output bit rate is determined automatically based on
the input source symbol rate and FEC value. This setting is used
when the signal source is RF.
The output rate is specified as the Output Rate parameter. It is
determined by the user setting regardless of the input source. Null
packets are always inserted.
78-4039426-01 Rev D