Cisco D9824 Installation And Configuration Manual page 157

3 Set the Frequency Tuning Mode, which determines whether to use the NIT to
tune to other transports, or to force the tuning to user configuration settings.
Select NIT and the receiver can change tuning parameters to use all transports
available in the NIT. Select User Cfg to force the receiver to use the user selected
tuning parameters.
4 The Service List mode determines which tables are required for tuning.
Rigorous requires all service list tables to be present to acquire the signal.
Degraded requires any service list table to be present to acquire the signal.
5 In the Network Information Table (NIT) drop-down menu, select Yes to use the
NIT when creating the service list.
6 In the Service Description Table (SDT) drop-down menu, select Yes to use the
SDT when creating the service list.
7 In the Program Association Table (PAT) drop-down menu, select Yes to use the
PAT when creating the service list.
Note: You cannot change the Bouquet Association Table value. It is not
supported in the current release.
8 Click OK.
9 Enter the Network ID of the uplink signal the receiver is to receive when using
the selected preset. The receiver's network ID must match the network ID
associated with the transmitted signal that identifies the NIT to be used. You can
enter a value in the range from 1 to 65535. The default is 1.
10 Select how the conditional access will attempt to descramble the scrambled
programs. The behavior of this setting is different between PowerVu streams and
those that require a CAM.
For PowerVu Streams:
- Std - In standard mode, if a program is not authorized, even if some services
are not scrambled, the whole program will not be authorized.
- Open - In open mode, if a program is not authorized, any services in the
program that are not scrambled will still be available.
For Non-PowerVu (CAM) streams:
- Std - In standard mode, if a program's CA system is not supported by the
CAM, the channel is not authorized.
- Open - In open mode, all the program's CA systems are validated by the
CAM. The channel is always authorized.
11 The SI Receive Status section displays all the current SI Receive settings. It also
displays the source of last tuning and the last Preset Number activated. The
Service List From section displays the current settings of the allowed services
(BAT, NIT, SDT, PAT).
12 Click Apply.
78-4039426-01 Rev D
Setting up Input Information
135