Cisco D9824 Installation And Configuration Manual page 198

Chapter 5 Web GUI Setup and Monitoring
10 Enter the Source UDP Port number (1 to 65535).
11 In the Send SAP drop-down list, select whether to send Session Announcement
Protocol messages (Yes or No).
12 In the SAP ID Source drop-down field, select whether to send the user
configured string, defined in the User SAP Identifier below, as the output
stream name in a SAP announcement (Yes or No). You can enter the SAP
identifier string, up to 49 characters.
Note: If the SAP ID Source is set to No, the User SAP Identifier is not used.
13 Click Advanced. The Advanced MPEG over IP Output Settings window is
displayed.
14 In the Maximum Transport Packets/Ethernet Frame field, enter the maximum
number of transport packets per IP packet (1 to 7).
15 In the Minimum number Packets/Second field, enter the minimum number of
transport packets per IP packet. You can enter 3 to 9999.
16 The Start Ethernet Frame on PCR is not supported.
17 In the PCR Addition Enabled drop-down list, select whether to add a PCR to the
output stream (Yes or No).
18 In the Interface 1 or 2 Port drop-down lists, select whether to transmit output on
the Data 1 and/or Data 2 Ethernet interface.
Note: If No Output was selected for Output Mode, updates to the port modes
will have no effect.
The following describes each mode:
Data Port
No Output
Always Output
176
Description
Disables the MPEGoIP interface.
Always output data on the port.
78-4039426-01 Rev D