Cisco D9824 Installation And Configuration Manual page 153

The following table describes the Current Input Status information displayed:
Parameter
Downlink Frequency
(GHz)
L band Frequency (MHz) The current L-Band frequency, in MHz.
Symbol Rate (Msym)
FEC
Modulation Type
Pilots
I/Q
Signal Status
TS ID
Input
Acquisition State
Orbital Validation
23 Click Apply.
78-4039426-01 Rev D
Description
The current downlink frequency, in GHz.
Symbol rate of the received signal, in Msymbols/second.
The FEC (Forward Error Correction) rate of the received signal
(N/A, 1/2, 3/5, 2/3, 3/4, 4/5, 5/6, 7/8, 8/9 or 9/10).
The modulation type for the received signal (N/A, QPSK, 8PSK,
DVB-S or DVB-S2).
Indicates whether a Pilot is present for the received signal. The
Pilot is set on the modulator for input signal synchronization
purposes.
The IQ (Input Signal Inversion) for the received signal (Inv or
NonInv).
Indicates whether the input signal is locked.
Locked - Indicates the receiver is locked to a carrier

with no valid content.
Lock+Sig - Indicates the receiver is locked to a carrier

with valid content.
No Lock - Indicates the receiver is not locked to a

carrier.
The Transport ID (in the range from 1 to 65535).
The active input port receiving the signal (RF1, RF2, RF3, RF4, or
ASI).
Displays Full if the ASI and PSI tables have all been found.
Otherwise, it will display Degraded if there are missing tables or
None if no ASI or PSI tables have been found.
Displays the last date that the Validate Orbital Position
operation was performed.
Setting up Input Information
131