Cisco D9824 Installation And Configuration Manual page 191

5 Click Edit. The DPM PE PID MAP window opens.
6 Enter the Output Channel # you want to map to the input channel (Input
Channel #). This value is only used if the PE Action was set to Map. You can
enter a range from 1 to 65535.
7 Enter the Output PMT PID you want to map to the Input PMT PID.
8 In the PE PID MAP section, you can select an existing PID mapping entry you
want to modify or click Add Row to create a new entry.
9 The Input Stream indicates the input service that will be mapped by the current
entry. The Input PID displays the input PID (1 to 8190) that will be mapped by
the current entry. This is only used if the Action is set to Map.
10 In the Action drop-down, select the action to perform on the current PID. The
Drop action is always performed, but the Map option is only applied if the PE
action is Map and the Remapping Mode is Svc ID & PID.
Action
Drop
Map
11 Enter a Stream Type to map within a PE to a specified PID (0 to 255).
12 Select the Category or service to configure. If an input service matches this type
and Instance, then the Action will be applied. This value is only used if the
Action is set to Map. The categories are: UNKN, CDT, LSDT, DATA, TTX, MPE,
DPI, VBI, SUBT, AUD, VID, PCR or INVL.
13 Enter the Instance (1 to 64) of the service specified by Category to configure. If
an input service matches this type and instance, then the Action will be applied.
14 If Action is set to Map, select the Output PID number (0 to 8192).
15 Click OK.
78-4039426-01 Rev D
Description
The service selected by the Category and Instance will be mapped
to the specified PID. This is only applied if the PE action is Map
and the Remapping Mode is Svc ID & PID.
The service selected by the Category and Instance will be removed
from the PMT and the output stream.
Configuring Transport Stream Information
169