Cisco D9824 Installation And Configuration Manual page 202

Chapter 5 Web GUI Setup and Monitoring
Map Mode
Svc ID & PID
21 Select the Duplication Method of the DPM program, which modifies the PSI to
duplicate a program and its content. This parameter is only used if Remapping
Mode is set to Svc ID & PID. The following table describes the each duplication
method:
Duplic Mode
PSI Remap
Pkt Copy
Pkt Copy is recommended for most applications.
22 Select the DPM action to use for Unreferenced Content. Unreferenced content is
the remainder of the transport that is not filtered by the program entries. Select
Drop (default) to drop all unreferenced content. Select Pass to pass all
unreferenced content to the output unchanged. Select Mode-i and then click
Mode-i Options to open the Mode-i Options (MOIP) window.
Mode-i is a customer-specific mode, only to be used if directed by Cisco. For
more information, contact Cisco customer support.
23 In the Service ID Output drop-down, select whether the receiver should always
generate PSI tables for the Mapped PE even if the selected input channel is not
available, or for only valid service channels/IDs. The following table describes
each service ID:
Svc ID
Valid Ch
180
Description
Channels and the elementary service PIDs can be mapped.
Description
Every input PID can be mapped to one output PID. If PID
mapping conflicts exist, DPM will use the Precedence Rule to
decide which output PID to use. All PMTs using the input PID
will be updated to reference the output PID specified by the
winner.
An input PID can be mapped to multiple output PIDs. The PID
will be duplicated as many times as needed (up to a certain
hardware limitation).
Description
Only transmits the PSI tables for the mapped program if the
program exists on the input stream.
78-4039426-01 Rev D