Cisco D9824 Installation And Configuration Manual page 194

Chapter 5 Web GUI Setup and Monitoring
Svc ID
Valid Ch
All Ch
25 If PSI Table Output Option is set to Ctrl by Table, select the regeneration rate for
those PSI tables being regenerated in the SI Regeneration Option drop-down
menu. This parameter is only used if Remapping Control is set to None. The
following table describes each PSI rate:
PSI Rate
Auto
MPEG Min
SA Std
26 In the PSI Table Output Option drop-down menu, select the action to perform
on the PSI tables for the output stream. The following table describes each
option:
PSI Options
Pass All
Drop All
Ctl By Table
27 In the PSI Regeneration Option drop-down, select whether to regenerate the PSI
tables to the output. You can select Always to regenerate all the tables or As
Needed to only regenerate the tables if the content has changed.
28 If Ctl By Table was selected as the PSI Table Output Option, click Table
Options to configure the DPM table options. The DPM Table Options (ASI)
window is displayed.
172
Description
Only transmits the PSI tables for the mapped program if the
program exists on the input stream.
Transmits the PSI tables for the mapped program even if the
program does not exist in the input stream.
All Ch is only valid if the PAT, NIT, SDT and PMT are set to
Regenerate.
Description
Matches the generated PSI tables' output rate to the incoming rate.
Transmits the generated PSI tables on the longest intervals that are
allowed by MPEG standard.
Transmits the generated PSI tables based on PowerVu standard
intervals.
Description
Transmits the incoming PSI Tables as is; does not modify the
content and rate. The SI Regeneration Option and table settings are
ignored.
Does not transmit any PSI Tables. The SI Regeneration Option and
table settings are ignored.
The operator can click Table Options to select the table specific
output mode for each table.
78-4039426-01 Rev D