Setting Up Input Information; Setting Up The Rf Input - Cisco D9824 Installation And Configuration Manual

Chapter 5 Web GUI Setup and Monitoring

Setting up Input Information

Setting up the RF Input

1 From the user interface of the D9824, click Input > Input Setup. The Input Setup
page is displayed.
2 In the RF Input Selection section, select Use RF Input to activate an RF input.
You can select RF 1 to RF 4 below.
3 Select UserCfg in the Input Selection to lock to the RF input set by the user.
Select SW Map to use the orbital position settings to select the RF input. It is
recommended that you validate the orbital position for SW Map option.
4 Select an RF input to activate (Use RF 1, Use RF 2, Use RF 3, or Use RF 4).
5 In the Tuning section, enter the current operating Downlink Frequency used by
the receiver for tuning the received digital signal. You can enter a value in the
range from 0.0 to 15.0 GHz.
6 Type the Symbol Rate. The symbol rate must match that of transmitted signal.
You can enter a value in the range from 1.0 to 45.0 Ms/s for DVB-S, 1.0 to 30.0 for
DVB-S2 if Pilot Present is set to Yes on the Front Panel, or 5.0 to 30.0 for DVB-S2
if Pilot Present is set to No on the Front Panel.
7 Select the Forward Error Correction (FEC) inner code rate. The FEC rate must
match the FEC of the transmitted signal. You can select 1/2, 2/3, 3/4, 5/6, 7/8,
or Auto.
8 Select the Modulation type for the received signal (DVB-S or DVB-S2).
128 78-4039426-01 Rev D